CASE-IH > BALERS > SQUARE BALERS > IH > (425) - INTERNATIONAL HARVESTER RECTANGULAR BALER (1/76-12/85)

(2) - INTRODUCTION (May 8 2002 3:22:00.0027 PM) (3) - INTRODUCTION - CONTINUED (A-02[A]) - SAFETY CHAIN (A-02[B]) - SMV EMBLEM AND LIGHT BRACKET SOCKET (A-02) - PRODUCT GRAPHICS (A-03) - HITCH (A-04) - HITCH PIVOT ASSEMBLY (A-05) - BALE CHAMBER (A-06) - BALE TENSION, MANUAL (A-07) - MAIN FRAME (A-08) - WHEEL AND AXLE RH (A-09[A]) - WHEEL RELOCATOR LH ATTACHMENT (A-09) - WHEEL AND AXLE LH (A-10) - POWER TAKE-OFF DRIVE SHAFT CLUTCH (A-11) - PTO SHAFTS WITH CHAINS, REAR, FITTED WITH LIP SEAL JOURNAL UNITS (A-12) - PTO DRIVE SHAFT, 26 IN. MINIMUM COMPRESSION FOR USE ON TRACTORS WITH 14 IN. STD DRAWBAR (A-13) - PTO SHAFTS WITH CHAINS, FRONT, FITTED WITH LIP SEAL JOURNAL UNITS (A-14[A]) - PTO SHAFT SUPPORT (A-14) - PTO CENTER BEARING AND BRACKET (A-15) - MAIN DRIVE (A-16) - PLUNGER STOP, UP TO 1979 (A-17) - PLUNGER STOP, 1980 AND SINCE (A-18) - PLUNGER (A-20) - PACKER DRIVE (A-22) - PACKER BEARINGS AND SUPPORT (A-23) - PACKER FINGER (A-24) - CROSS CONVEYOR (A-25) - FEED OPENING (A-26) - NEEDLES AND NEEDLE GUARD (A-27) - SLACK ARM (A-28) - KNOTTER DRIVE FRAME AND BREAST PLATE (A-29) - KNOTTER AND RELATED PARTS (A-30) - KNOTTER DRIVE CHAIN AND REAR SHAFT (A-31) - KNOTTER (A-32) - TUCKER FINGERS, UP TO 1979 (A-33) - TUCKER FINGERS, 1980 AND SINCE (A-34[A]) - AUGER DRIVE CHAIN (A-34) - KNOTTER SHAFT BRAKE (A-35) - AUGER AND AUGER DRIVE SUPPORT (A-36) - PICKUP GAUGE WHEEL ATTACHMENT (A-37) - PICKUP (A-39) - PICKUP DRIVE (A-40) - PICKUP COVER (A-41) - TWINE CHEST (A-42) - BALE LENGTH CONTROL (A-43) - BALE COUNTER (A-44) - BALE CHUTE ATTACHMENT (A-45) - BALE CHAMBER EXTENSION (A-46) - PLUNGER CRANK SHIELD (A-47) - LIFTING JACK (A-48) - SPECIAL SHIELDS (A-49) - FLYWHEEL SHIELD (A-50) - HITCH CLEVIS STRAP (A-51) - TRAILER HITCH (A-52[A]) - TOOLBOX (A-52) - BALE TURNER ATTACHMENT, WHEN ORDERED