| № | Номер | Название | Опции | Альт |
|---|
| 1 | D147040 | HARNESS | side console, used with D146664 alarm wire, Ref. 12 on Figure 4-52 on models with audible warning alarm, prior to P.I.N. JJG0167019 | | | 1a | 110884A1 | HARNESS | side console, includes wiring for audible warning alarm, D146664 wire, Ref. 12 on Figure 4-52, not required with this harness, P.I.N. JJG0167019 and after, replaces 101597A1 | | | D134737 | IGNITION SWITCH | SWITCH ASSEMBLY key, includes keys, Includes: Ref. 2, 3 and 4. | | | 2 | NSS | NOT SOLD SEPARAT | SWITCH key, without keys | | | | PLASTIC PLUG THE IGNITION SWITCH GOES INTO IS P/N 225253C1, PACKARD NUMBER IS 2984017 PER PRINT. | | | | 3 | A77314 | NUT | key switch mounting | | | 4 | A77313 | SET OF 2 KEYS | KEY, set of two; metal without padding | | | 5 | D144977 | ELECTRICAL WIRE | WIRE ground, key switch, uses existing hardware | | | 6 | L71879 | DIODE ELEMENT,400V, 3A | DIODE alternator protecting | | | 7 | 281-45510 | SELF-TAP SCREW,Hex Wash Hd, #10 x 5/8" | SCREW self-tapping, hex washer head, No. 10 NF x 5/8 inch | | | 8 | A149803 | FUSE,25 Amp | 25 amperes | | | | THE FUSE BLOCK THAT REF. 8, 9 and 10 FUSES GO IN IS 245435C1. THERE WOULD BE 3 USED AS PICTURED HERE. | | | | | COVER FOR THE FUSE BLOCK IS ON Fig. 9-130. | | | | 9 | A149800 | FUSE,10 Amp | 10 ampere, red | | | | THE FUSE BLOCK THAT REF. 8, 9 and 10 FUSES GO IN IS 245435C1. THERE WOULD BE 3 USED AS PICTURED HERE. | | | | 10 | A149801 | FUSE,Lt Blue, 15 Amp | 15 ampere, light blue | | | | THE FUSE BLOCK THAT REF. 8, 9 and 10 FUSES GO IN IS 245435C1. THERE WOULD BE 3 USED AS PICTURED HERE. | | | | 11 | 1546541C1 | RELAY | switch, 75 ampere, replaces D144471 relay | | | 12 | 413-416 | BOLT,Hex, 1/4" - 20 x 1", Gr 5 | hex, 1/4 NC x 1 inch | | | 13 | 492-11025 | LOCK WASHER,1/4" | WASHER, LOCK, , 2 of the 3 washers are at the lower mounting hole 1/4" | | | 14 | 493-11026 | LOCK WASHER,Ext-Int Tooth, 1/4" | lower mounting hole only Ext-Int Tooth, 1/4" | | | 15 | 193-1006 | NUT,Keps, w/LW, 1/4"-20 | ASSEMBLY, includes washer, 1/4 inch, NC | | | 16 | D150166 | HARNESS | transaxle shift lever switch to side console harness | | | 17 | D141486 | SWITCH | clutch cutout, transaxle shift lever handle | | | 18 | D140149 | PROTECTOR | COVER square, switch, if used | | | 18a | D138252 | BOOT | COVER round, switch, if used | | | 19 | D71346 | TAIL LAMP,12V | BULB warning, No. 168, transmission filter | | | 20 | 515-23254 | CLAMP,1", Insul, 3/8" Bolt | P-type 1", Insul, 3/8" Bolt | | | 21 | 515-23190 | CLAMP,3/4", Insul, 3/8" Bolt | P-type, 3/4 inch | | | 22 | 281-14812 | SELF-TAP SCREW,Hex Washer, 5/16" - 18 x 3/4" | SCREW self-tapping, hex washer head, 5/16 NC x 3/4 inch, retains, side console harness clamps to underside of chassis, replaces D141589 bolt | | | 23 | 515-23190 | CLAMP,3/4", Insul, 3/8" Bolt | harness, closed, 3/4 inch ID, uses side console hardware for mounting, replaces 49771 | | | 24 | D150427 | SLEEVE | GUARD, 150 mm long, sleeve, harness, cut to required length from D99461 bulk guard, see below | | | 25 | L18337 | CABLE TIE,9.95"-12.1" lg | STRAP tie, 15 inch, nylon | | | D99461 | LOOM | GUARD, 2032 mm long, sleeve, bulk | |
|
|